Florida CCC 1326909

What occurs during a roofing inspection

What occurs during a roofing inspection

What occurs during a roofing inspection

Most people head to see their doctor at least annually to make sure that their body is working properly. Your roof needs that same type of care. Therefore, it is important to hire roofing contractors in Daytona to inspect your roof on a regular basis. This inspection should occur even if you do not think there has been any damage because just like cancer, diabetes or high blood pressure, you can never tell what is hiding underneath.

Roof Covering

The roof is designed to keep elements off the house underneath it. The inspector should look at the home’s location and structure to determine if the roof is adequately doing its job.

Fasteners

While it can be tricky to check the fasteners during a roof inspection, roofing contractors can tell if the proper fasteners have been used and if they are the right distance apart. They can also see if any fasteners have done damage to shingles or other roofing materials.

Deck Sheathing

The next part of a roof inspection should be to check the deck sheathing. Shingles and other roofing materials are only as good as the materials that they area fasted to, so the inspector should walk around the roof looking for any places that do not seem strong. In most cases, the sheathing is plywood, but other materials can be used.

Roof’s Slope

All roofs need some slope to them. If a home settles, then the slope may not be proper anymore. While this is often a foundation problem as opposed to a roof problem, it still needs to be inspected.

Drip Edge

One of the most common areas where roof damage is spotted is in the drip edge. This small metal piece helps to move water away from the fascia so that it does not get under the roof’s edge.

Offsetting

While each shingle manufacturer has their own recommendations, it is important that the shingles be offset across the roof instead of lining up in perfect rows to provide the best water protection.

Roof Valley Fastener

If the roof has two down-sloping parts, then a metal flashing should be located there to help water get down off the roof without seeping under either part of the roof.

Nail Penetration

If there are more than one layer of shingles, then sometimes nails that are too short have been used to try to attach the new layers of shingles. While it is hard to see the length of the nail, a good roofing inspector, like those available at Century Roofing Specialist, will tug on several shingles to make sure that they are securely attached.

Flashings

Any type of hole in the roof, such as a vent pipe, sunlight or chimney, should have flashings placed around it. Your roofing inspector will make sure that these are in place and are not cracked as they are one of the first places that many roofs leak.

It is time to get your roof inspected. Call roofing contractors in Daytona at 407-393-8888 for an inspection that you can count on to be honest.